Inspect a Forklift
There are more than 10,000 workplace injuries connected to forklifts happen each year, according to HRSDC and OSHA reports. Many of these mishaps are caused by operator error. Lack of proper equipment maintenance and check results in numerous others. Forklift maintenance and operation is not only the cause of personal injuries, but also of property damage. Forklifts could damage sprinklers, building structures and overhead pipes, and other machines when utilized incorrectly. The following day by day check ups must be done so as to lessen the chance of forklift accidents.
Prior to inspecting various fluid levels turn off the engine. Inspect these fluids: fuel, engine oil, hydraulic oil, brake fluid and coolant. The tires also have to be checked for signs of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest should be securely attached. Do a visual inspection of the top-clip retaining heel and pin. Next perform an inspection of the hydraulic hoses, mast chains, stops and cables. Ensure that both the overhead and finger guards are securely attached.
LP forklifts have propane tanks that have to be inspected for indications of corrosion, damage or rust. Test the battery's electrolyte levels and charge. All belts should be checked for wear. Check to make certain the owner's guidebook is kept on-board the forklift inside a storage compartment. Test the seat belt to make certain the latches are secure. Check the hood latch to ensure it is functioning as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate at once. Check the steering controls and the accelerator. The parking break and the service break must be working properly.
To ensure proper functioning in both reverse and forward, the drive control and tilt control must be inspected. The functioning of the hoist, the lowering control and attachment control requires periodic checking. Check the lights and horn. After that check the defroster, wipers and heater to make certain they are functioning well. Inspect each and every gauge to find out that it is reading within functional limits.