Most of the time, businesses will spend lots of money to purchase their forklifts. It is essential, therefore to take good care of your machinery to protect your investment into the long run. It is a good idea to know the procedures that are carried out during the care and maintenance of this piece of equipment.
One of the best ways to tell how good the engine is working is by starting the forklift up and listening closely to see how it works. For example, if there are any misses or knocks, the machinery is faulty and this must raise several issues. Also listen closely for any squealing noise which come from the belts because these noises will provide you with a lot of information.
When performing maintenance, some of the main components you will need to pay attention to comprise the safety warning devices, horn, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
After the above components have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every battery cell has to be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be frequently replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been done and new filters have been fitted, visually inspect the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. Next, inspect each and every other component of the machine including the wheels. If any type of concern or fault is detected, be sure to deal with it immediately so as to make sure the equipment is working at its safest and optimum levels.